| | | |
| c | 20 mm | | | d1 | 62 mm | | | d2 | 48 mm | | | d3 | 60 mm | | | da max | 63 mm | | installation size
if the rotary shaft seal is used, the outer diameter of seal ring must be considered. |
| | da min | 45 mm | | installation size
if the rotary shaft seal is used, the outer diameter of seal ring must be considered. |
| | h3 | 55 mm | | | r1 min | 0,6 mm | | | rmin | 0,3 mm | |
|
| m | 1,32 kg | | | ca | 80000 n | | basic rated dynamic load, axial direction |
| | c0a | 199000 n | | basic rated static load, axial |
| | cr | 24300 n | | basic rated dynamic load, radial |
| | c0r | 41500 n | | basic rated static load, radial |
| | ng öl | 4900 1/min | | limit speed for oil lubrication (only when there is a suitable cooling system) |
| | ng fett | 1400 1/min | | limit speed of grease lubrication |
| | mrl | 1,6 nm | | | cal | 3000 n/µm | | | ckl | 800 nm/mrad | | | mm | 4,51 kg x cm^2 | | weight moment of inertia of rotating inner ring |
| | 1 µm | | axial beat
the axial runout of the screw support bearing configuration is based on the inner ring rotation. |
| | zma25/58, am25 | | recommended code for ina locking nut |
| |
|
|
assembly
