| |  |     |
 | | | | | axial adjacent area of outer ring | | | | | the geometric tolerance described is required only when the diameter region is between dai and daa. | |
| | | | | | a2 | 35 mm | | | b | 16 mm | | | daa min | 26 mm | | | dai | 22 mm | | | d1 | | mm | | d2 | 4,5 mm | | | da | 12,4 mm | | | m | 26 mm | | | n | 26 mm | | | rmin | 0,3 mm | | | x | | | axial adjacent region of outer circle |
|
|
| m | 50 g | | | cr | 7400 n | | basic rated dynamic load, radial |
| | c0r | 3600 n | | basic rated static load, radial |
| | ca | 2550 n | | basic rated dynamic load, axial direction |
| | c0a | 2420 n | | basic rated static load, axial |
| | ng fett | 5100 1/min | | limit speed of grease lubrication |
| | mrl | 0,12 nm | | | cal | 26 n/µm | | axial stiffness
the statistical average measured over the entire bearing. |
| | mm | 0,0075 kg x cm^2 | | weight moment of inertia of rotating inner ring |
| | 7 µm | | axial beat
the axial runout of the screw support bearing configuration is based on the inner ring rotation. |
| | zm10 | | recommended code for ina locking nut
lock nut for axial positioning of the bearing unit. it does not affect the preloading of the bearing. |
| | | | the lock nut must be ordered separately. |
| | ma | 6 nm |
|
|
assembly
