| |  |     |
 | | | | | axial adjacent area of outer ring | | | | | the geometric tolerance described is required only when the diameter region is between dai and daa. | |
| | | | | | a2 | 51 mm | | | b | 22 mm | | | daa min | 35 mm | | | dai | 29 mm | | | d1 | | mm | | d2 | 6,6 mm | | | da | 17,5 mm | | | m | 39 mm | | | n | 35 mm | | | rmin | 0,3 mm | | | x | | | axial adjacent region of outer circle |
|
|
| m | 140 g | | | cr | 16700 n | | basic rated dynamic load, radial |
| | c0r | 10700 n | | basic rated static load, radial |
| | ca | 16400 n | | basic rated dynamic load, axial direction |
| | c0a | 22400 n | | basic rated static load, axial |
| | ng fett | 3400 1/min | | limit speed of grease lubrication |
| | mrl | 0,2 nm | | | cal | 200 n/µm | | axial stiffness
the statistical average measured over the entire bearing. |
| | mm | 0,0178 kg x cm^2 | | weight moment of inertia of rotating inner ring |
| | 7 µm | | axial beat
the axial runout of the screw support bearing configuration is based on the inner ring rotation. |
| | zm15 | | recommended code for ina locking nut
lock nut for axial positioning of the bearing unit. it does not affect the preloading of the bearing. |
| | | | the lock nut must be ordered separately. |
| | ma | 10 nm |
|
|
assembly
