| | | d | 180 mm | | tolerance:k6
+0,004 / -0,021 |
| | daa | 225 mm | | | h | 22 mm | | bearing section height
tolerance: +/-0,13 | bearing section height
| | | di | 202,8 mm | | | dm202 mm | | | da | 201,2 mm | | | h | 22 mm | | height of a single ring
tolerance:e8
-0,025 |
| | rmin | 1,1 mm | | | s | 2 mm | | lubrication hole: three holes with equidistant distribution on the circumference | |
| | | m | 2,3 kg | | | 0,015 mm | | operation accuracy，radial |
| | 0,010 mm | | | sr min | 0,005 mm | | | sr max | 0,025 mm | | | sk min | 0,010 mm | | | sk max | 0,05 mm | | | rlomax | 0,005 mm | | small clearance: radial clearance |
| | rlomax | 0,010 mm | | small clearance:preloading |
| | vspmin | 0,005 mm | | minimum bearing preloading |
| | vspmax | 0,025 mm | | maximum bearing preloading |
| | ca | 96000 n | | basic rated dynamic load, axial direction |
| | c0a | 380000 n | | basic rated static load, axial |
| | cr | 69000 n | | basic rated dynamic load, radial
（for pure radial loads only） |
| | c0r | 153000 n | | basic rated static load, radial
（for pure radial loads only） |
| | ng öl | 755 1/min | | limit speed for conventional clearance oil lubrication |
| | ng fett | 375 1/min | | limit speed of grease lubrication under general clearance |
| | ng öl | 375 1/min | | limit speed with preloading oil lubrication |
| | ng fett | 185 1/min | | preloading limit grease lubrication speed |
| | 61836 | | size consistent with iso size series 18 |
|
|
|
|
|
|
