| | | d | 240 mm | | tolerance:k6
+0,005 / -0,024 |
| | daa | 300 mm | | | h | 28 mm | | bearing section height
tolerance: +/-0,13 | bearing section height
| | | di | 270,8 mm | | | dm270 mm | | | da | 269,2 mm | | | h | 28 mm | | height of a single ring
tolerance:e8
-0,025 |
| | rmin | 2 mm | | | s | 2 mm | | lubrication hole: three holes with equidistant distribution on the circumference | |
| | | m | 5,3 kg | | | 0,020 mm | | operation accuracy，radial |
| | 0,010 mm | | | sr min | 0,010 mm | | | sr max | 0,030 mm | | | sk min | 0,020 mm | | | sk max | 0,06 mm | | | rlomax | 0,005 mm | | small clearance: radial clearance |
| | rlomax | 0,010 mm | | small clearance:preloading |
| | vspmin | 0,005 mm | | minimum bearing preloading |
| | vspmax | 0,025 mm | | maximum bearing preloading |
| | ca | 148000 n | | basic rated dynamic load, axial direction |
| | c0a | 640000 n | | basic rated static load, axial |
| | cr | 105000 n | | basic rated dynamic load, radial
（for pure radial loads only） |
| | c0r | 255000 n | | basic rated static load, radial
（for pure radial loads only） |
| | ng öl | 565 1/min | | limit speed for conventional clearance oil lubrication |
| | ng fett | 280 1/min | | limit speed of grease lubrication under general clearance |
| | ng öl | 280 1/min | | limit speed with preloading oil lubrication |
| | ng fett | 140 1/min | | preloading limit grease lubrication speed |
| | 61848 | | size consistent with iso size series 18 |
|
|
|
|
|
|
