| | | d | 70 mm | | tolerance:k6
+0,004 / -0,015 |
| | daa | 90 mm | | | h | 10 mm | | bearing section height
tolerance: +/-0,10 | bearing section height
| | | di | 80,5 mm | | | dm80 mm | | | da | 79,5 mm | | | h | 10 mm | | height of a single ring
tolerance:e8
-0,01 |
| | rmin | 0,6 mm | | | s | 1,2 mm | | lubrication hole: three holes with equidistant distribution on the circumference | |
| | | m | 0,3 kg | | | 0,010 mm | | operation accuracy，radial |
| | 0,010 mm | | | sr min | 0,003 mm | | | sr max | 0,015 mm | | | sk min | 0,006 mm | | | sk max | 0,03 mm | | | rlomax | 0,003 mm | | small clearance: radial clearance |
| | rlomax | 0,006 mm | | small clearance:preloading |
| | vspmin | 0,003 mm | | minimum bearing preloading |
| | vspmax | 0,015 mm | | maximum bearing preloading |
| | ca | 15400 n | | basic rated dynamic load, axial direction |
| | c0a | 51000 n | | basic rated static load, axial |
| | cr | 11000 n | | basic rated dynamic load, radial
（for pure radial loads only） |
| | c0r | 20400 n | | basic rated static load, radial
（for pure radial loads only） |
| | ng öl | 1910 1/min | | limit speed for conventional clearance oil lubrication |
| | ng fett | 955 1/min | | limit speed of grease lubrication under general clearance |
| | ng öl | 955 1/min | | limit speed with preloading oil lubrication |
| | ng fett | 475 1/min | | preloading limit grease lubrication speed |
| | 61814 | | size consistent with iso size series 18 |
|
|
|
|
|
|
